How to Check the Engine Oil Level
- With the engine at operating temperature and turned off, check the oil level on the dipstick.To get a true reading, the vehicle should be on a level spot.
- After turning off the engine, wait a few minutes for the oil to drain back into the bottom of the engine.
- Pull out the dipstick and wipe it with a clean rag.
- Re-insert the dipstick. Push it in as far as it will go or the reading will not be correct.
- Pull the dipstick out and look at the oil level on the end.
- Caution: Be careful not to touch the hot exhaust manifold
How & When to add oil?
- If the oil level is below or only slightly, above the low level, add engine oil of the same type as already in the engine.
- Remove the oil filter cap and add engine oil in small quantities at a time, checking the dipstick.
- When the level reaches within the correct range, install the filter cap and hand-tighten.
How to Check the Engine Coolant Level
- Look at the see-through coolant reservoir when the engine is cold.
- The coolant level is satisfactory if it is between the “F” and the “L” lines on the reservoir.
- If the level is low, add coolant of the same type as already in the system.
- The coolant level in the reservoir will vary with engine temperature, however if the level is on or below the “L” line, add coolant.
- Bring the level up to the “F” line.
- Always use the same type of coolant as already in the cooling system.
- If the coolant level drops within a short time after replenishing, there may be a leak in the system.
- Visually check the radiator cap, drain plug and water pump.
- If you can find no leak, have your Lexus dealer test the cap pressure and check for leaks in the cooling system.
- Caution: To prevent burning yourself, do not remove the radiator cap when the engine is hot.
What Coolant Type Must I Use?
- Use only genuine Lexus Long Life Coolant 50% mixture.
- Notice: Do not use alcohol type antifreeze or plain water alone.